Auto water trap is usually used to drain the water of the port where is lower, segregator, gas store pot and the bottom of gas filter. It is installed where it is not easy to drain the sewage with manpower, for example high, low or narrow place and especially where using large gas or drain water continually. It is can prevent the compressor air from re-polluting by water condensate. Drain automatically, no needs manual operation Dustproof; durable and reliable Standard parts are equipped with body case.

Our product can act for the of the same kind imports the product.竊�/span>SMC��/span>AIRTAC

Specification竊�/span>

��/span> Notice:
1.When install the drainpipe,please use the pipe whose inner diameter is more than 10mm,and the length should not exceed 5mm,and the pipe should not be bend upward
2.The compressor power should larger than 3.7kw.

Out line size diagram/structural diagram竊�/span>mm竊�/span> Main parts: Part No. Name Material 1 Body Aluminum die casting Parts list: Parts No. Name Material Model KAD402-04 2 竊�/span>ring NBR JIS B2401P-8 3 竊�/span>ring NBR 113136 4 Net SUS ��/span> Working principle: 1) When there is no pressure in the cup The floater (5)will go down,valve(9)colse the pore(6),pistion (8)is pressed down by spring(11),then the condensed water passed the drain hole(12). 2) When there is pressure When the pressure is larger than 1kgf/cm2,then the piston (8) conquers the spring and push up ward,and the drain hole closed,the inner of cup is isolated from the ourside. 3) When there is condensed water in the cup When the quantity of condensed water reaches to a certain degree,the floater (5)will rise,and pore(6)open,the pressure enter into the inner chamber,then the piston (8)is pressed down by pressure and spring(11),and the condensed water passed the discharge pipe (13)and drain.